DTC Confirmation Test "A"
WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
Malfunction is detected when IACV-AAC valve does not operate properly. Possible causes are:
- Idle Air Control Valve-Auxiliary Air Control (IACV-AAC) valve circuit open.
- Defective IACV-AAC valve.
Connect scan tool to Data Link Connector (DLC). See Figure . Raise drive wheels, and support vehicle. Using scan tool, select DATA MONITOR. Start engine and let idle. Increase engine speed to 2500 RPM for 3 seconds, then let idle for 3 seconds. Increase engine speed to 2500 RPM for 3 seconds, then let idle for 3 seconds. If first trip DTC is sets, perform DIAGNOSTIC PROCEDURE . If first trip DTC is not set, perform DTC CONFIRMATION TEST "B" .