Section 4 (MULTIPORT Fuel Injection (MFI) - 2.4L (1 Of 6))
WARNING: This page is about a different variant/trim than selected.
- General Information
- General Specification(S)
- Service Specification(S)
- Sealant And Adhesive
- Special Tool
- MULTIPORT Fuel Injection (MFI) Diagnosis
- Troubleshooting Strategy
- Diagnostic Function
- Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp)
- How To Connect The Scan Tool (M.U.T.-III)
- How To Read And Erase Diagnostic Trouble Codes
- How To Read Data List
- How To Perform Actuator Test
- How To Diagnose The Can Bus Lines
- How To Read Provisional Diagnostic Trouble Codes
- Confirmation Method
- Permanent DTC
- Procedures For Erasing Permanent DTC
- Mode 6 Reference Table
- On-Board Diagnostics
- OBD-II Drive Cycle
- Pattern 1
- Pattern 2
- Pattern 3
- Pattern 4
- Pattern 5
- Pattern 6
- Pattern 7
- Pattern 8
- Pattern 9
- Pattern 10
- Pattern 11
- Pattern 12
- Pattern 13
- Pattern 14
- Pattern 15
- Pattern 16
- Pattern 17
- Pattern 18
- Pattern 19
- Pattern 20
- Pattern 21
- Pattern 22
- Pattern 23
- System Readiness Test Status
- Fail-Safe Function Reference Table
- Diagnostic Trouble Code Chart
- Symptom Chart