LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2015 >> Outlander GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (MULTIPORT Fuel Injection (MFI) - 2.4L (1 Of 6)) >> Service Specification(S)

Service Specification(S)

WARNING: This page is about a different variant/trim than selected.
ITEMS STANDARD VALUE
Fuel pressure kPa (psi) Approximately 324 (47) at curb idle
Intake air temperature sensor resistance kΩ -20°C (-4°F) 13 - 18
0°C (32°F) 5.3 - 6.7
20°C (68°F) 2.3 - 3.0
80°C (176°F) 0.30 - 0.45
Engine coolant temperature sensor resistance kΩ -20°C (-4°F) 14 - 17
20°C (68°F) 2.1 - 2.7
80°C (176°F) 0.26 - 0.36
Heated oxygen sensor output voltage V 0.6 - 1.0
Linear air-fuel ratio sensor heater resistance Ω 2.3 - 4.2 [at 20°C (68°F)]
Heated oxygen sensor (rear) heater resistance Ω 4.5 - 8.0 [at 20°C (68°F)]
Injector coil resistance Ω 10.5 - 13.5 [at 20°C (68°F)]
Throttle actuator control motor coil resistance Ω 0.3 - 100 [at 20°C (68°F)]
Oil feeder control valve coil resistance Ω 6.9 - 7.9 [at 20°C (68°F)]