Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

STEP 1. Fluid check
Check for the fluid level and if no foreign material and contamination are found.

Q: Is the check result normal?
1. YES: Go to Step 2.
2. NO: Charge or replace the fluid.
STEP 2. Retest the system.
Q: Does a malfunction take place again?
1. YES: Replace the clutch assembly. (Refer to TRANSAXLE .) Then go to Step 3.
2. NO: Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
STEP 3. Retest the system.
Q: Does a malfunction take place again?
1. YES: Replace the mechatronic assembly. (Refer to << A >> MECHATRONIC ASSEMBLY REMOVAL .) Then go to Step 4.
2. NO: Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)
STEP 4. Retest the system.
Q: Does a malfunction take place again?
1. YES: Replace the transaxle assembly. (Refer to << B >> TRANSAXLE ASSEMBLY CONNECTOR REMOVAL
2. NO: Intermittent malfunction. (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .)