LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Liftgate - Vehicles With Power Liftgate - With Diagnostics) >> Diagnostic Trouble Code Procedures >> DTC U0245: AND CAN Time-out >> Diagnosis

DTC U0245: AND CAN Time-out: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus line 
    CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
    1. Connect scan tool (M.U.T.-III). Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)
    2. Turn the ignition switch to the "ON" position.
    3. Diagnose the CAN bus line.
    4. Turn the ignition switch to the "LOCK" (OFF) position.

    Q: Is the CAN bus line found to be normal? 

    • YES:  Go to Step 2.
    • NO:  Repair the CAN bus line (Refer to DIAGNOSIS ).
  2. STEP 2. Using scan tool (M.U.T.-III), read the radio and CD player diagnostic trouble code 

    Check if DTC is stored to the MMCS

    Q: Is the DTC stored? 

    • YES:  Troubleshoot the MMCS (Refer to DIAGNOSIS .)
    • NO:  Go to Step 3.
  3. STEP 3. Using scan tool (M.U.T.-III), read the other system diagnostic trouble code. 

    Check if DTC U0245 is stored in the KOS-ECU, OSS-ECU, combination meter, ETACS-ECU or A/C-ECU.

    CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T.-III).
    1. Connect scan tool (M.U.T.-III). Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)
    2. Erase the DTC.
    3. Turn the power supply mode of the engine switch to ON.
    4. Check if DTC is stored.
    5. Turn the power supply mode of the engine switch to OFF.

    Q: Is the DTC stored? 

    • YES:  Go to Step 4.
    • NO:  Go to  Step 5.
  4. STEP 4. Recheck for diagnostic trouble code. 

    Check again if the DTC is stored in the power liftgate control unit.

    1. Erase the DTC.
    2. Turn the power supply mode of the engine switch from OFF to ON.
    3. Check if DTC is stored.
    4. Turn the power supply mode of the engine switch from ON to OFF.

    Q: Is the DTC stored? 

  5. STEP 5. Recheck for diagnostic trouble code. 

    Check again if the DTC is stored in the power liftgate control unit.

    1. Erase the DTC.
    2. Turn the power supply mode of the engine switch from OFF to ON.
    3. Check if DTC is stored.
    4. Turn the power supply mode of the engine switch from ON to OFF.

    Q: Is the DTC stored? 

scientia non olet · About LEMON Manuals