LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Continuously Variable Transaxle (CVT) On-Vehicle Service - With Diagnostics) >> Diagnosis < S-AWC > >> Symptom Procedures >> INSPECTION PROCEDURE 6: When the ECO Mode Switch is Turned On, the Drive Mode is not Switched into AWC ECO Mode >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Scan tool (M.U.T.-III) data list 

    Check the following data list (Refer to DATA LIST REFERENCE TABLE ).

    • Item No.408: Filler lid Open SW/ECO mode SW

    Q: Is the check result normal? 

    1. YES:  Go to  Step 4.
    2. NO:  Go to Step 2.
  2. STEP 2. Follow the ETACS-ECU trouble symptom procedure "The hazard indicator assembly (ECO mode switch) signal is not received." 

    Refer to Inspection Procedure 19: The hazard indicator assembly (ECO mode switch) signal is not received

    Q: Is the check result normal? 

    1. YES:  Go to  Step 4.
    2. NO:  Repair it. Then go to Step 3.
  3. STEP 3. Retest the system. 

    Q: Does the malfunction occur again? 

    1. YES:  Go to Step 4.
    2. NO:  This diagnosis is complete.
  4. STEP 4. Scan tool (M.U.T.-III) DTC. 

    Check whether an ETACS-related DTC is stored in the AWC-ECU (Refer to DIAGNOSTIC TROUBLE CODE CHART  ).

    Q: Is the DTC stored? 

    1. YES:  Perform the relevant troubleshooting. Then go to Step 5.
    2. NO:  Go to Step 5.
  5. STEP 5. Retest the system. 

    Q: Does the malfunction occur again? 

    1. YES:  Diagnose again from  Step 1.
    2. NO:  This diagnosis is complete.
scientia non olet · About LEMON Manuals