LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Continuously Variable Transaxle (CVT) On-Vehicle Service - With Diagnostics) >> Diagnosis < CVT > >> Diagnostic Trouble Code Procedures >> DTC P0815: Malfunction of paddle shift UP switch < Vehicles with paddle shift > >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. STEP 1. Scan tool (M.U.T.-III) data list 

    Item 54: Paddle shift SW (UP) (Refer to DATA LIST REFERENCE TABLE  ).

    OK: The service data changes in response to the paddle shift operation. 

    Q: Is the check result normal? 

    1. YES:  Intermittent malfunction
    2. NO:  Go to Step 2.
  2. STEP 2. Paddle shift switch single unit check 

    Refer to PADDLE SHIFT ASSEMBLY  .

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Replace the paddle shift switch.
  3. STEP 3. Check for short to ground in PDUP line between the TCM connector and the paddle shift switch connector 

    Q: Is the check result normal? 

    1. YES:  Go to Step 4.
    2. NO:  Repair the connector(s) or wiring harness.
  4. STEP 4. Symptom recheck after erasing diagnostic trouble code 

    Q: Is the check result normal? 

    1. YES:  Intermittent malfunction
    2. NO:  Replace TCM.
scientia non olet · About LEMON Manuals