Installing high pressure pump

NOTE: RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.

Do not use any metal-cutting tools.

NOTE: RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

NOTE: TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.

Feed in and install high pressure pump (2) .
Replace screws (1) .
Parts: Screws

Position the screws (1) of the high pressure pump (2) and tighten in alternating order in 90° increments.

TIGHTENING TORQUES SPECIFICATION

High pressure pump to high pressure pump flange
M6x25	Replace screws. Joining torque	12Nm
	Tightening torque	90°

Guide the special tool 2 413 106 out and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide the fuel delivery line (2) in and install.
Make sure that the rubber damper (3) is positioned correctly.

Tighten union nut (1) .

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Fuel delivery line to high pressure pump
M14	Tightening torque	26Nm

Follow-up work

Refer to INSTALL THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE RAIL AND THE HIGH-PRESSURE PUMP .
Refer to INSTALLING THE IGNITION COILS .
Refer to IF INSTALLED: PARTIALLY INSTALL ENGINE VENTILATION LINE .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE UPPER BULKHEAD COVER PANEL .
Refer to INSTALLING THE STRUT BRACE .
Refer to CONNECTING ALL BATTERY GROUND LEADS .
Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
Refer to MOUNTING THE WHEEL .
Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .