Remove lumbar support
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: 72 00 SAFETY REGULATIONS ON HANDLING COMPONENTS WITH GAS GENERATORS
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: 72 00 SAFETY REGULATIONS ON HANDLING COMPONENTS WITH GAS GENERATORS .
Preliminary work
- Refer to REMOVING THE FRONT STRAP FITTING .
- Refer to REMOVING FRONT SEAT .
- Refer to REMOVING INNER COVER .
- Refer to REMOVING THE COVER FOR BACKREST ADJUSTMENT .
- Refer to REMOVING THE STEERING LEVER FOR BACKREST ADJUSTMENT .
- Refer to REMOVING THE LEVER FOR SEAT HEIGHT ADJUSTMENT .
- Refer to REMOVING THE OUTER COVER ON THE FRONT SEAT .
- Refer to REMOVING THE REAR PANEL FROM THE FRONT SEAT BACKREST .
- Refer to REMOVING THE TRIM AT THE BOTTOM OF THE APERTURE .
- Refer to REMOVING SIDE AIRBAG FROM FRONT SEAT .
- Refer to REMOVING THE BACKREST COVER WITH THE CUSHION .
- Detach lumbar support (3) from the holders (1) and backrest frame (2).
- Cover working area and drill out blind rivet (1).
- Remove adjuster (2) and take it out with the Bowden cable from the backrest frame.