51 23 400 Removing and installing/replacing left or right actuator (active pedestrian protection)
WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Adhere to the following SAFETY INSTRUCTIONS
so as to avoid a injury hazard by the actuator.
The BATTERY NEGATIVE LEAD must be clamped off prior to work on the actuator or engine compartment lid!
Do not exert any force on the actuator.
Incorrect handling may result in triggering of the actuator and thereby cause serious injury.
The BATTERY NEGATIVE LEAD must be clamped off prior to work on the actuator or engine compartment lid!
Do not exert any force on the actuator.
Incorrect handling may result in triggering of the actuator and thereby cause serious injury.
Necessary preliminary work:
- Disconnect CABLE from battery earth lead
- Remove WINDSHIELD PANEL COVER
Removal
Unfasten plug connection (1) and disconnect.
Release bolt (2) and remove actuator (3).
Installation
Install actuator (3) and tighten bolt (2).
Tightening torque 41 61 3AZ .
Connect the connector (1).