51 11 156 Remove and install front bumper cover

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Removal:

Release trim (1) from detents (2) and clips (3).

NOTE: Carry out work on the right side in the same way as for the left side illustrated here.

Fig 1: Releasing Trim From Detents And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Fig 2: Front Bumper Cover Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Fig 3: Front Bumper Cover Screws Location (F55, F56 And F57)

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Pull bumper cover (2) slightly towards the front with aid of a support person.

Unlock and disconnect all plug connections depending on equipment specification.

Remove bumper cover (2) towards the front with the aid of a support person.

Fig 4: Pulling Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position bumper cover (2) with the aid of a second person.

Connect all plug connections.

Tighten down screws (1).

Tightening torque 51 11 1AZ .

Fig 5: Pulling Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Fig 6: Front Bumper Cover Screws Location (F55, F56 And F57)

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Fig 7: Front Bumper Cover Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Fasten trim (1) on detents (2) and clips (3).

NOTE: Carry out work on the right side in the same way as for the left side illustrated here.

Fig 8: Releasing Trim From Detents And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Adjust GAP DIMENSIONS BUMPER