62 30 010 Removing and installing head-up display
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Attention !
Observe the information on PROTECTION FROM ELECTROSTATIC DISCHARGE .
Attention !
Comply notes on HANDLING OPTICAL FIBRES .
Risk of damage!
Do not hold the Head Up Display by the heat sink.
If possible, do not touch the sound insulation on the Head Up Display.
Do not touch the glass pane of the Head- Up Display if possible.
Necessary preliminary tasks:
- Remove INSTRUMENT PANEL TRIM
Removal:
Loosen screws.
Carefully feed Head-Up Display (1) out of support (2) towards top.
Unlock connector (1) on underside of head-up display (2) and disconnect.
Remove head-up display (2).
Installation:
Connect connector (1) on underside of head-up display (2).
NOTE:
Make sure installation position of Head- Up Display (1) relative to support (2) is correct.
Join Head-Up Display (1) with support (2).
Tighten the screws.
Tightening torque 62 30 1AZ .