61 00... Notes on handling optical fibres
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
To avoid damage when handling optical fibres, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibres to compressive and tensile load
- Protect optical fibres against the effects of heat ≥85 °C (e.g. during welding work, drying work with infrared beams or hot air blower)
- Fibre-optic cables are permitted to show only one junction point (bridge), replace fibre-optic cables if necessary
NOTE:
The optical fibres are colored differently as follows:
- Green = MOST (M edia O riented S ystems T ransport) optical fibre
- Yellow = ISIS (I ntelligent S afety and I ntegration S ystem) optical fibre
- Orange=repair fibre-optic cables
Follow notes for processing cables and optical fibres: See CUTTING OFF/STRIPPING INSULATION/CUTTING TO LENGTH and CRIMPING OPTICAL FIBRES .