65 77 016 Removing and installing/replacing airbag control unit (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe the NOTE airbag safety regulations!

Failure to observe correct procedures can deploy the airbag and cause injuries.

Attention!

Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Preliminary work needed:

Disconnect BATTERY GROUND LEAD.
Remove CENTER CONSOLE .

Removal:

Detach cable clip (1).

Release nut (2) and screw (3).

Take off holder (4).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Unlock plug connections (2) and disconnect.

Remove airbag control unit (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position airbag control unit (3).

Tighten down nuts (1).

Tightening torque 65 77 1AZ .

Join and lock plug connections (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Position holder (4).

Tighten nut (2) and bolt (3).

Attach cable clip (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install CENTER CONSOLE .
Connect BATTERY GROUND LEAD.
Run the service function to adjust the sensors for the driving dynamics as follows:

Chassis
Traction control system
Adjustment of the driving dynamics sensors

Replacement:

Carry out PROGRAMMING/CODING .