Disconnecting and connecting battery ground lead (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Observe and follow SAFETY INSTRUCTIONS for handling vehicle battery.

,
Comply with NOTES for disconnecting and connecting the vehicle battery and
INSTRUCTIONS on intelligent battery sensor (IBS).

Removal:

Partially detach seal (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen cap nuts (1).

Open locks (2) by turning them counter-clockwise.

Remove windshield panel cover (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen nut (1).

Remove battery ground lead (2).

Unlock connector (3) from IBS and disconnect.

Secure battery ground lead (2) at the side.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect the connector (3) to the IBS.

Join battery ground lead (2).

Tighten nut (1).

Tightening torque 61 21 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Thread in the windshield panel cover (3).

Turn the locks (2) to the right until the stop is reached.

Tighten cap nuts (1).

Tightening torque 61 21 6AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Join gasket (1).

Courtesy of BMW OF NORTH AMERICA, INC.