REP-TAT-P-5462-02 Installing left or right rollover protection system
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Follow-up work
- Install the RELEASE UNIT for the left or right rear seat backrest
- Secure the REAR SEAT BELT
- Install the TRIM PANEL of the roll bar on the side
- Retract the ROLLOVER PROTECTION SYSTEM
- Install the SEAT BELT FINISHER STRIP
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position rollover protection system (4).
- Replace screws (3).
Parts: screw
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATION
Rollover protection system to body M8x20 Replace screws. 28 Nm - Tighten down screw (2).
- Connect connectors (1) and lock.
- Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATION
Rollover protection system to body M8x20 Replace screws. 28 Nm - Replace screws (2).
Parts: screw
- Tighten screws (2).
TIGHTENING TORQUE SPECIFICATION
| Rollover protection system to cross member |
| M8x45 |
| Replace screws. |
| 25 Nm |