Removing and installing/replacing actuator for left or right rear seat backrest (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Microencapsulated screws must be coated with Loctite if they are to be reused
- Screw connection must be completed within 20 min. (start of harden)
- Microencapsulated screws must not be retightened.
- Thread of nut must be cleaned beforehand in event of repeated use
Preliminary work needed:
- Remove LOCK for rear seat backrest.
Removal:
Lift detent (1) slightly.
Feed out actuator (2) with guides (3).
Installation:
Insert actuator (2) with guides (3).
Clip in actuator (2) with detent (1).
Required follow-up work:
- Install LOCK for rear seat backrest.