REP-TAT-P-1151-02-6 Installing coolant pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Inspection:
- Check whether the sealing bead (1) is glued to the housing of the coolant pump.
- Check sealing bead (1) for damage.
- Measure the height of the sealing bead (1) in relation to the surface.
SEALING BEAD HEIGHT SPECIFICATION
| Height of the sealing bead | |
|---|---|
| 2.0 mm... 2.5 mm | |
Result
« Sealing bead (1) is damaged or the measured dimension deviates.
Measure
- Remove the sealing bead (1).
NOTE:
The processing time of the liquid sealing compound can be at a maximum of 10 min.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
Commissioning of the assembly is not possible until 25 minutes after the processing time.
Non-observance can lead to leaks in the assembly.
- Reapply the sealing bead (1).
- Have the special tool 2 469 803
ready.
- Position the sealing compound (1) as shown on the special tool 2 469 803
.
Parts: Sealing compound
Sealing compound Loctite 5970 liquid sealing compound Processing time <10 minutes at room temperature 50 ml, Cartridge 1
83190404517 - Tighten screws (2) and (3) of the coolant pump (1).TIGHTENING TORQUE SPECIFICATION
Coolant pump to component carrier M6 screw 9 Nm
Follow-up work:
- Connect right charge air duct to the charge air cooler:
Insert the charge air duct on the charge air cooler, till the lock (1) engages on both sides.
- Install the DRIVE BELT FOR ALTERNATOR .
- Install RIGHT CHARGE AIR LINE .
- Install front underbody protection with the THRUST FIELD .
- Fill and vent the COOLANT CIRCUIT .