Replacing the coolant temperature sensor (B36, B38, B46, B48) (Cooper)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic discharge (ESD protection).
WARNING:
Risk of scalding!
Only perform this repair work on an engine that has cooled down.
Only perform this repair work on an engine that has cooled down.
Recycling
Catch and dispose of leakage coolant.
Observe country-specific waste disposal regulations.
Preliminary work needed :
- Remove INTAKE PORT .
Removal :
Unlock connector (1) and detach.
Release and remove coolant temperature sensor (2).
Replace gasket.
Part : Gasket.
Installation:
Screw in and tighten coolant temperature sensor (2).
Tightening torque 13 62 5AZ .
Attach connector (1).
Connector (1) must engage audibly.
Required follow-up work :
- Install INTAKE PORT .
- Check coolant level, top up if necessary
- Check cooling system for leaks.