Remove and install/replace hot film air mass meter (Cooper)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic discharge (ESD protection).

Removal :

Unlock connector (1) and detach.

Unscrew the screws (2).

Remove the hot film air mass meter (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation :

Install hot film air mass meter (3).

Tighten down screws (2).

Tightening torque 13 62 6AZ .

Attach connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Reset the adaptation values for the air mass system with the MINI diagnostic system using an appropriate scan tool.