Replacing pulse sensor on intake camshaft (B36, B38) (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic discharge (ESD protection)!
Preliminary work needed:
- Remove ACOUSTIC COVER
Removal:
Unlock connector (1) and detach.
Remove screw (2).
Remove pulse generator (3).
Installation:
Check gasket, replace damaged gasket.
Part : Gasket
Install pulse sensor (3).
Tighten screw (2).
Tightening torque 13 62 1AZ .
Attach connector (1) on pulse sensor.
Connector (1) must engage audibly.
Required follow-up work:
- Install the ACOUSTIC COVER .