REP-TAT-P-6121-02 Install battery
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Follow-up work
- Install BATTERY COVER
- Install the left WINDSHIELD PANEL COVER
- Install the rear HOOD SEAL
- Install INTAKE SILENCER HOUSING
- Install INTAKE PORT
- Insert and install vehicle battery (4).
- Insert the holder with the screw (3) and install.
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATION
| Retaining rail to battery carrier |
| Hexagon screw |
| Tightening torque |
| 15 Nm |
- Connect the air bleeder hose (arrow) to the battery (2).
- Insert and install the positive battery cable (1).
- Tighten the nut on the positive battery cable (1).
TIGHTENING TORQUE SPECIFICATION
| Positive battery terminal to battery |
| Nut M6 |
| Tightening torque |
| 5 Nm |
- F56 Battery Electric Vehicle:
Feed in the heat pump controller (4) and position correctly.
Clip in the cable clip (2).
Connect connectors (1) and lock.
Replace screws (3).
Parts: screws.
Tighten the screws (3).
- Install the tension strut (1).
- Tighten the screws (arrows).
TIGHTENING TORQUE SPECIFICATION
| Tension strut to battery tray |
| MB |
| Tightening torque |
| 19 Nm |
- Install the mount (1) for the seal and secure with the expanding rivet (arrow).
- Thread in and install battery earth lead (2).
- Tighten the nut (1).
TIGHTENING TORQUE SPECIFICATION
| Battery terminal clamp on battery terminal |
| M6 |
| Tightening torque |
| 5 Nm |
- Connect connectors (3) and lock.
The connector (3) must engage audibly.