Removing and installing power distribution box (front) (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
,
Comply with NOTES for disconnecting and connecting the vehicle battery and
INSTRUCTIONS on intelligent battery sensor (IBS).
Observe and follow SAFETY INSTRUCTIONS for handling vehicle battery.
,
Comply with NOTES for disconnecting and connecting the vehicle battery and
INSTRUCTIONS on intelligent battery sensor (IBS).
Preliminary work needed:
- Remove TRIM for bottom right dashboard.
- Remove right GLOVE COMPARTMENT with housing.
Removal:
Remove screw (1).
Feed out power distribution box (2) from support (3).
Installation:
Feed in power distribution box (2) into support (3).
Tighten screw (1).
Tightening torque 61 14 3AZ .
Required follow-up work:
- Install right GLOVE COMPARTMENT with housing.
- Install bottom right INSTRUMENT PANEL TRIM .