Removing and installing/replacing the front left or right rubber window seal (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove front door WINDOW GLASS .
- Remove the window CHANNEL STRIP on the front door on the inside
IMPORTANT:
The instructions on installation of RUBBER WINDOW SEALS serve as the basis for these repair instructions and must be observed without fail.
Removal:
Slightly fold back the rubber window seal (1).
Remove screw (2).
Feed out corner trim (1) upwards out of guide (2) and remove.
Pull out the rubber window seal (1) from the window guide rail (2).
Installation:
The rubber window seal (1) must not be damaged at corners (2).
Coat the rubber WINDOW SEAL (1) with approved lubricant prior to installation.
Insert the rubber window seal (1) into the window guide rail (2).
Feed in corner trim (1) into guide (2).
Tighten screw (2).
Tightening torque 51 33 3AZ .
Mount the rubber window seal (1).
Required reworking:
- Install front door WINDOW GLASS .
- Install the window CHANNEL STRIP on the inside of the front door.