Venting clutch hydraulic system (Cooper)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Connect bleeder unit to brake fluid expansion tank.
- Remove front UNDERBODY PROTECTION .
- Remove THRUST FIELD
IMPORTANT:
Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.
Remove the dust cap from the bleed valve (1).
Insert air bleeder hose (2) into bleed valve (1).
Open bleed valve (1) and flush until clear brake fluid leaks out without air bubbles.
Close bleed valve.
Switch off bleeder unit or remove from expansion tank.
Correct brake fluid level in expansion tank.
Required follow-up work:
- Install THRUST FIELD
- Install front UNDERBODY PROTECTION .
- Remove bleeder unit from brake fluid expansion tank.
IMPORTANT:
Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.