Removing and installing/replacing optional equipment system (SAS) control unit (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The optional equipment system (SAS) is a control unit in which the functions of the suspension control systems and the assist systems are integrated.
IMPORTANT:
Read and comply with NOTES
on protection against electrostatic discharge (ESD protection)!
Preliminary work needed:
- Disconnect BATTERY GROUND LEAD. .
Removal:
Remove cover (1) of right luggage compartment TRIM PANEL .
Unlock and disconnect plugs (1).
Loosen screws (2).
Remove SAS control unit (3).
Installation:
Position SAS control unit (1).
Insert nuts (2) and tighten.
Tightening torque 34 51 6AZ .
Connect plug connection (3).
Install cover (1).
Required follow-up work:
- Connect BATTERY GROUND LEAD.
- Replacement only: Perform the PROGRAMMING/CODING .