REP-TAT-P-5218-01 Removing backrest frame

WARNING: Airbag unit.
Danger! Immobilization period-threatening injuries!

Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: NOTES airbag safety regulations!

WARNING: Pyrotechnic components.
Danger! Immobilization period-threatening injuries!

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see: NOTES airbag safety regulations!

Preliminary work

Remove the COVER for backrest adjustment

Remove the STEERING LEVER for backrest adjustment

Remove the LEVER for seat height adjustment

Remove the OUTER COVER on the front seat

Remove TRIM for backrest release

Remove the REAR PANEL from the front seat backrest

Remove the TRIM at the bottom of the aperture

Remove SIDE AIRBAG from front seat

Remove the BACKREST COVER with the cushion

When replacing the backrest frame: REMOUNT COMPONENTS

NOTE: Perform the steps on the right and left side.

Loosen screws (4).
Completely remove the backrest frame (5) to the top.
If necessary, feed out the relative cable and set aside rear seat backrest.

Courtesy of BMW OF NORTH AMERICA, INC.