11 51 000 Removing and installing/replacing coolant pump (N16)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!
Only perform these tasks on an engine that has cooled down.

Recycling:

Catch and dispose of drained coolant.

Observe country-specific waste disposal regulations.

Installation note:

All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
Retaining elements on chassis and suspension and steering parts must be replaced.

Necessary preliminary tasks:

Remove FRICTION GEAR .

Release screws (1).

Remove coolant pump (2) downwards.

Installation note:

Replace gasket.

Clean sealing surfaces.

Fig 1: Identifying Coolant Pump Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Bleeding instructions must be observed . Refer to VENT COOLING SYSTEM/CHECK ON WATERTIGHTNESS or BLEED/FILL COOLING SYSTEM WITH VACUUM FILLING UNIT .