12 41 020 Removing and installing/replacing starter (N18 AWD)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Switch off ignition.
Clamp off BATTERY .
Remove INTAKE PLENUM .

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Release screw.

Tightening torque 12 41 1AZ .

Fig 1: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release connector (1) and remove.

Release nut (2) and remove the positive battery cable.

Tightening torque 12 41 2AZ .

Release screws.

Tightening torque 12 41 1AZ .

Remove bracket (3) and starter from the top.

Fig 2: Identifying Connector, Holder And Cable Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install starter motor and fit screws.

Press starter motor (1) in direction of arrow and tighten down.

Fig 3: Installing Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.