63 12 015 Removing and installing (replacing) left headlight (Adaptive Headlight)

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release screws (1). Tightening torque 63 12 1AZ .

Disconnect plug connection (2).

Pull headlight forwards slightly and disconnect hose connection (3) from high-pressure nozzle (4).

Remove headlight.

Fig 1: Identifying High Pressure Nozzle, Hose Connection, Plug Connection, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Adjust body gap dimensions by means of adjusting screws (1)

Fig 2: Body Gap Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust HEADLIGHTS

Fig 3: Identifying Adjusting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify XENON BULB FOR HEADLIGHTS
Modify BULB FOR TURN INDICATOR
Modify CONTROL UNIT FOR XENON HEADLIGHTS
Modify POWERTRAIN/ELECTRONICS BOX FOR ADAPTIVE HEADLIGHT
Modify HIGH-PRESSURE NOZZLE of headlight cleaning system
Modify adjusting screws