LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4161 (Engine Assembly, Cylinder Head, Oil Pan, Timing Case Cover, Crankcase Ventilation System - Repair) >> Engine Assembly >> 11 00 Mounting Engine On Assembly Stand (S63)

11 00 Mounting Engine On Assembly Stand (S63)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

WARNING:

Remove engine with hoist and special tool 11 0 020 .

Fit special tool 11 8 930 on engine.

Engine weighs approx. 280 kg.

Necessary preliminary tasks: 

- Remove FRONT AXLE WITH ENGINE .

- Remove engine from front axle (if engine is still installed on front axle). See REMOVING ENGINE FROM FRONT AXLE (M6, DUAL-CLUTCH TRANSMISSION)  or REMOVING ENGINE FROM FRONT AXLE (M6, MANUAL TRANSMISSION) .

- Clean contact surfaces.

Use special tool 11 8 931 to mount special tool 11 8 932 .

Insert screws (1 and 2).

Tightening torque: 11 11 9AZ .

Fig 1: Identifying Special Tool And Screws
G00554311Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 11 8 931 to mount engine on special tool 00 2 300 .

Tightening torque: 11 11 10AZ

Graphic shows engine N63.

Fig 2: Mounting Engine On Special Tool (00 2 300) Using Special Tool (11 8 931)
G05907609Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals