11 00 670 Securing engine in installation position (N63O1)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
WARNING:
Danger of injury!
Observe following instructions relating to special tool:
Observe following instructions relating to special tool:
- Prior to each use, check the special tools for defects, modifications and operational reliability.
- Damaged/modified special tools must not be used!
- No changes or modifications may be made to the special tools!
- Keep special tools dry, clean and free of grease.
IMPORTANT:
Before lifting the engine, check the lifting lugs for damage (cracks) and to ensure they are seated securely.
NOTE:
- NUMBERING SYSTEM FOR SPECIAL TOOLS has been re-encoded.
IMPORTANT:
Special tool 00 6 100
must not be fitted when cross-member (1) is installed!
Necessary preliminary tasks:
- Secure the engine compartment lid in the service position. See 51 00... SERVICE POSITION OF ENGINE COMPARTMENT LID .
- Remove trim panel for engine compartment lid at side. See 51 76 035 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT ENGINE COMPARTMENT LID SEAL LOCATOR .
- Remove underbody protection at front and rear. See 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION and 51 47 491 REMOVING REFITTING/REPLACING REAR ENGINE UNDERCOVER .
- Remove stiffening plate . See applicable procedure for drivetrain configuration: 31 11 040 REMOVE AND INSTALL/REPLACE STIFFENING PLATE (ALL-WHEEL DRIVE) , 31 11 040 REMOVING AND INSTALLING/REPLACING STIFFENING PLATE or 31 11 040 REMOVING AND INSTALLING/REPLACING STIFFENING PLATE (M6) .
Completion of cross-member 00 6 100 with adapters 00 6 130
T-pieces 2 318 635 and facings 00 6 050.
NOTE:
Contact points (1) for special tool 00 6 050 are pictured.
IMPORTANT:
Risk of damage!
Position transverse member 00 6 100 with a 2nd person helping on contact points ().
WARNING:
Danger of injury!
Align all struts and feet.
Tighten down all screws and nuts on cross-member 00 6 100 .
Attach hook (1) of engine lifting beam in lifting eye.
Ensure that supports 00 6 050/53 and 00 6 050/52 are correctly seated.
Slightly pretension the spindle of the engine support beams.
IMPORTANT:
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its add-on parts) and the body.
Always make sure there is sufficient clearance between the engine (or its add-on parts) and the body.
Release screws (1) of engine mount.
Tightening torque 22 11 1AZ .
Raise engine approx. 10 mm with cross member.