31 53 040 Removing and installing/replacing right output shaft bearing block

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

REMOVE right output shaft.

Release holder (1) from bearing support.

Unfasten screws (2).

Tightening torque 31 60 1AZ .

Remove bearing block (3) from oil sump.

Installation note:

Replace O-RING .

Replace SHAFT SEAL .

Fig 1: Identifying Bearing Block, Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.