37 14 521 Replacing front left ride-height sensor

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

NOTE: Jointed rod on upper control arm 37 14 5AZ .

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Release COOLANT EXPANSION TANK and place to one side
NOTE: Level switch can slip out when coolant expansion tank is removed.

Release screw (1).

Installation:

Align ride-height sensor holder by means of lug (2) to opening under screw (1).

Tightening torque 37 14 1AZ .

Fig 1: Identifying Lug And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release nut (2) and disconnect jointed rod.

Installation:

Sensor lever (3) must point from ride-height sensor to left front wheel.

Replace self-locking nut.

Tightening torque 37 14 4AZ .

Fig 2: Identifying Plug Connection, Nut And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove holder (2).

Tightening torque 37 14 3AZ .

Fig 3: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out RIDE-HEIGHT CALIBRATION
Check HEADLIGHT ADJUSTMENT , correct if necessary