37 12 012 Carrying out ride height adjustment
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride-height-calibration must be carried out after the following work:
- Removal/replacement of ride-height sensor or its control rod
- Replacement of wiring harness
- Replacement of air supply unit control unit
- Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis system.
Switch the ignition on.
Carry out ride-height-calibration (menu item: "Service function").
Version with Run Flat Indicator: initialize RUN FLAT INDICATOR
Version with Tyre Pressure Control: carry out RESETTING