11 65 180 Removing and installing/replacing heat shield at top (N63 hybrid)

Necessary preliminary tasks:

• Remove both INTAKE FILTER HOUSINGS
• Remove both control sensors. See LEFT CONTROL SENSOR  and RIGHT CONTROL SENSOR .

Release screws (1).

Lift out holder.

Fig 1: Identifying Intake Filter Housing Holder Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 11 65 3AZ .

Fig 2: Identifying Intake Filter And Housing Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 11 65 3AZ .

Fig 3: Identifying Intake Filter And Housing Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Detach wire ring (2) and set down behind oxygen sensor.

Fig 4: Identifying Oxygen Sensor Wire Ring And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Detach wire ring (2) and set down behind oxygen sensor.

Fig 5: Identifying Oxygen Sensor, Wire Ring And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 11 65 3AZ .

Fig 6: Identifying Oxygen Sensor Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 11 65 3AZ .

Lift out heat shield.

Fig 7: Identifying Heat Shield Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.