11 78 533 Replacing right control sensor (N63 hybrid)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 7 020

WARNING: High-voltage system - danger to life!

WARNING: Scalding hazard!
Only perform this work after engine has cooled down.

Necessary preliminary tasks:

Check function of DME control unit
Turn off ignition
Remove AIR FILTER HOUSING

Unlock plug connection and detach.

Unclip control sensor cable from bracket.

Release control sensor with special tool 11 7 020 .

Fig 1: Removing/Installing Control Sensor Using Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

The threads of new lambda control/monitoring sensors are already coated with Never Seez Compound (refer to BMW Parts Department).

If a lambda control/monitoring sensor is to be reused, apply a thin and even coating of Never Seez Compound to the thread only.

Secure control sensor with special tool 11 7 020 and a torque wrench (1).

Tightening torque 11 78 1AZ .

Fig 2: Removing/Installing Control Sensor Using Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check function of DME control unit.

Pay attention to cable routing of control sensor.