3441140 Removing and installing or replacing guide tube for handbrake cables
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Disconnect BATTERY NEGATIVE LEAD
- Remove AIRBAG CONTROL UNIT
- Remove PROPELLER SHAFT
Lock adjuster unit (ASZE).
Actuate parking brake lever. Position special tool 32 1 030 . Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).
Installation:
Unlock adjuster unit (ASZE).
Lever out restraining hook (2) with a suitable screwdriver.
Restraining hook (2) must detach from stop (1) of adjusting spring.
Press retainer (1) in balance arm (2) forward in direction of arrow.
Detach handbrake Bowden cables (3) from balance arm (2).
Pull handbrake cables out of guide tube.
Release screws (1).
Release screws (2) and feed out guide tube (3) towards bottom.
Installation:
Replace seal.
Tightening torque 34 41 4AZ .
After installation
- Adjusting PARKING BRAKE