24 34 022 Replacing sealing cup for transmission housing (GA8HP45Z) (N55)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale transmission oil vapors.
- Wear protective gloves.
- Ensure adequate ventilation
NOTE:
After completing work:
- Load specific data status with the BMW diagnosis system
IMPORTANT:
After completion of work, CHECK TRANSMISSION OIL LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission.
Necessary preliminary tasks:
- Remove transmission OIL SUMP .
- If required, remove OIL ACCUMULATOR .
- Remove CROSSMEMBER .
IMPORTANT:
Support transmission with workshop jack.
Unlock and disconnect connector (1) by turning.
Insert special tool 24 2 390 (cap) in sealing sleeve (1).
Release screw (1) and unlock sealing cup with slide (2).
Tightening torque: 24 30 4AZ
NOTE:
Make a note of installation position of sealing sleeve.
Pull out sealing cup (1).
Installation note:
Fit sealing sleeve in position (lug on inner surface). Turn until lug engages in groove of transmission. Slide in sealing cup.
Lug on sealing sleeve must not be damaged!