51 44 013 Removing and installing roofliner (on version with panorama sunroof)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove both sun visors and counter supports, see 51 16 080 Removing and installing or replacing sun visor and left or right counter support
- Remove all handles, see 51 16 450 Removing and installing/replacing rear left/right grab handle
- Remove both trim panels for front roof pillar (A-pillar trim panel), see 51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right
- Remove both trim panels for top door pillar (B-pillar trim panel), see 51 43 148 Removing and installing or replacing trim on left or right door pillar (top)
- Remove both trim panels for rear roof pillar (C-pillar trim panel), see 51 43 251 Removing and installing/replacing trim panel for rear left or right roof pillar (C - pillar)
- Remove both trim panels for rear roof pillar (D-pillar trim panel), see 51 43 252 Replacing trim panel for rear left or right roof pillar (D-pillar)
- Remove trim on front roofliner, see 51 44 ... Removing and installing front roofliner trim
- Remove front and rear head restraints
- Remove all ceiling lights
Version with dividing net mounts:
If necessary, remove all dividing net mounts:
Unclip trim (1) towards bottom and remove.
Installation:
Guide (1) and catches (2) of trim (3) must not be damaged.
- Move both front seat backrests as far back as possible.
- Remove roller cover from luggage compartment.
- Fold both rear-seat backrests forward.
- Pull off mucket of front and rear doors.
IMPORTANT:
The following tasks must be carried out with a second person assisting:
Unclip clips (1) in sunroof frame area towards bottom.
Unclip clips (1) in sunroof frame area towards bottom.
Extend rear roofliner towards bottom out of guide.
Turn headliner and remove towards rear.
Installation:
Clips (1) and guide (2) must not be damaged.
If necessary, replace clips (1) and guide (2).