51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Follow safety instructions for working on cars with airbag systems (risk of injury), see 51 00 ... Safety instructions for working on cars with airbag systems
IMPORTANT:
Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).
Detach mucket (1) in area of panel (6).
Unclip protective cap (2) and remove.
Release screw (3).
Tightening torque: 51 43 2AZ, see 51 43 SIDE TRIM PANEL WITH ARMRESTS
Unclip panel (6) at fastening point (4).
Feed out panel (6) from instrument panel (5) and remove.
Installation:
If necessary, lever out clip (1) remaining in bore.
If necessary, replace faulty clip (1).
Make sure guides (3) of panel (2) are correctly seated in associated mountings.
Position panel (2) preinstalled with clip (1) on associated bore and clip into place.