63 12 015 Removing and installing/replacing left headlight (adaptive headlight)
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by specialist personnel.).
Follow Instructions For Handling Light Bulbs (Exterior Lights) .
Necessary preliminary tasks:
- Remove Front Bumper Trim
Unlock catches (1) in direction of arrow and remove high-pressure nozzle (2) towards rear out of headlight arm (3).
Release screw (1) on headlight arm (2) (from wheel arch side).
For tightening torque refer to 63 12 1AZ in 63 12 HEADLIGHTS .
Release screws (1). For tightening torque refer to 63 12 3AZ in 63 12 HEADLIGHTS .
Installation:
If necessary, unclip electric lead (2) from headlight arm. Pull out headlight (3) slightly and unlock and disconnect associated plug connection.
Remove headlight (3) towards front.
Replacement:
- Release screws (1) (for tightening torque refer to 63 12 2AZ in 63 12 HEADLIGHTS ) and remove headlight arm (2) from headlight.
- Remove Ignition Unit With Bulb For Xenon Headlight
- Remove Control Unit For Xenon Headlights
- If necessary, Remove Bulbs .