Section 1899 (Engine Controls - Pinpoint Test JE: Integrated Ignition Coil Pack A, B, Or C Failure Through Pinpoint Test KP: Charge Air Cooler (CAC) Pump - (Except Diesel & Hybrid))
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
- Pinpoint Test JE: Integrated Ignition Coil Pack A, B, or C Failure
- Pinpoint Test JF: Integrated Ignition Coil On Plug Coil A Through J Failure
- Pinpoint Test JH: Tachometer Signal Output (CTO)
- Pinpoint Test KA: Fuel Pump (FP) Relay
- Pinpoint Test KB: Fuel Pump Driver Module
- Introduction
- Notes
- Fuel Pump Driver Module (FPDM) Connector
- Fuel Pump Driver Module 2 (FPDM2) Connector
- Fuel Pump Driver Module Power (FPDM PWR) Relay Connector
- Fuel Pump Driver Module 2 Power (FPDM2 PWR) Relay Connector
- Fuel Pump/Rear Electronics Module Power (FP/REM PWR) Relay Connector
- Inertia Fuel Shutoff (IFS) Connector
- FPDM PWR Relay Integral to the PDJB
- Power Distribution Junction Box (PDJB) Connector
- Powertrain Control Module (PCM) Connector
- Test Procedure
- Introduction
- Pinpoint Test KD: Electric Exhaust Gas Recirculation (EEGR) System
- Pinpoint Test KE: Idle Air Control (IAC) Valve
- Pinpoint Test KF: Fan Control (FC) Relays
- Pinpoint Test KJ: Supercharger Bypass Control
- Pinpoint Test KM: Air Conditioning Clutch Relay (A/CCR) Circuit
- Pinpoint Test KN: Variable Speed Electric Cooling Fan
- Pinpoint Test KP: Charge Air Cooler (CAC) Pump