Remove/Install Engine Hood Lifter - AR91.60-P-0900S
Model 223
with code U60 (Pedestrian protection - Active hood)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/install | |||
| 1 | Disconnect ground line of battery of 12 V on-board electrical system. | AR54.10-P-0051S | |
| 2 | Remove rear section of front fender liner. | Model 223 with code U60 (Pedestrian protection - Active hood) except code 228 (Additional warm water heating) Model 223.0/1 with code U60 (Pedestrian protection - Active hood) except code 228 (Additional warm water heating) |
AR88.10-P-1301S |
| 3 | Remove heater. | Model 223 with code 228 (Additional warm water heating) with code U60 (Pedestrian protection - Active hood) When removing right hood lifter. |
AR83.70-P-5302S |
| 4 | Release electrical connector (1) and disconnect. | ||
| 5 | Unclip plug housing (2). | ||
| 6 | Remove bolt (3). | *BA91.60-P-1002-02A | |
| 7 | Extend hood lifter (4) upward out of hinge. | ||
| Check | |||
| 8 | Check hood lifter (4) for damage. | If there is a problem, ↓ Replace hood lifter (4) and dispose of defective hood lifter (4) properly. |
|
| 9 | Install in the reverse order. | ||
| 10 | Connect diagnostic device and check Supplemental Restraint System (SRS). | ||
| AD00.00-P-2000-06FR |
ENGINE HOOD LIFTER
| Number | Designation | Model 223 | |
|---|---|---|---|
| BA91.60-P-1002-02A | Screw/nut, hood lifter to body | Nm | 11 |