Remove/Install Oil Lines Of Oil Cooling For Automatic Transmission - AR27.55-P-0600MRK
Transmission 725.0 in model 167 with engine 264
Shown on removed front axle
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non - deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. Do not pour transmission oil into beverage bottles. |
AS00.40-Z-0001-01A | |
| Topical note | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Notes on automatic transmission | AH27.19-P-0001-01NKB | ||
| Remove/install | |||
| 1 | Remove front, center and rear lower engine compartment lining. | AR61.20-P-1105ME | |
| 2 | Thoroughly clean connections of oil lines (1, 3) on automatic transmission (5) and oil cooler (6). | Assembly cleaner | *BR00.45-Z-1028-04A |
| 3 | Unscrew screw (7) and remove bracket (9.1). | ||
| *BA27.55-P-1004-01D | |||
| *BA27.55-P-1005-01D | |||
| 4 | Remove screws (2, 4). | ||
| *BA27.55-P-1006-01D | |||
| 5 | Remove oil lines (1, 3) from oil cooler (6) and seal openings using suitable stop plugs. | AR27.10-P-0501-03LF | |
| *BR00.45-Z-1028-04A | |||
| Fig 1 | |||
| 6 | Remove oil lines (1, 3) from automatic transmission (5) and seal openings using suitable stop plugs. | AR27.10-P-0501-03LF | |
| *BR00.45-Z-1028-04A | |||
| Fig 1 | |||
| 7 | Remove oil lines (1, 3). | ||
| 8 | Remove retaining clamps from oil lines (1, 3). | If the oil lines (1, 3) are replaced. | |
| 9 | Install in the reverse order. | ||
| 10 | Check and correct oil level in automatic transmission (5). | AR27.00-P-0270EWN | |
| Check | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug - fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 11 | Perform engine test run and check oil lines (1, 3), automatic transmission (5) and oil cooler (6) for leak tightness. | ||
| 12 | Install front, center and rear lower engine compartment lining. | AR61.20-P-1105ME |
TRANSMISSION OIL COOLING
| Number | Designation | Transmission 725.0 | |
|---|---|---|---|
| BA27.55-P-1004-01D | Bolt, clamp to oil line | Nm | 8 |
TRANSMISSION OIL COOLING
| Number | Designation | Transmission 725.0 | |
|---|---|---|---|
| BA27.55-P-1005-01D | Bolt, clamp of oil cooler oil line to bracket | Nm | 8 |
TRANSMISSION OIL COOLING
| Number | Designation | Transmission 725.0 | |
|---|---|---|---|
| BA27.55-P-1006-01D | Screw, oil cooler oil line clamp to oil pan | Nm | 8 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1028-04A | Assembly cleaner | A 000 986 56 01 |