Remove/Install 360° Front Camera - AR54.30-S-3001E

Model 447, 448.8 

With Code JS1 (360° camera (SURROUND VIEW)) 

Model 447, 448 

With Code JB6 (Parking package with 360-degree camera) 

Model 447 

With Code EZ6 (Parking package with 360-degree camera) 

Courtesy of MERCEDES-BENZ USA

Shown With Code JS1 (360° camera) 

Courtesy of MERCEDES-BENZ USA

Shown With Code JB6 (Parking Package with 360° camera) 

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove radiator shell (1) far enough until electric line (2) is accessible.		AR88.00-S-2115E
2	Pull impact absorber (3) forward and expose electric line (2) up to electrical connector (5).	Model 447, 448.8 except code XM7 (Facelift II)
3	Disconnect electrical connector (5).
4.1	Remove radiator shell (1), remove screws (7) and remove holder (6) with front 360° camera (B84).	Model 447, 448.8 except code XM7 (Facelift II)
4.2	Remove locks (arrows A) and holder (11) and front 360° camera (B84).	Model 447, 448.8 with code XM7 (Facelift II)
5	Unclip front 360° camera (B84) from holder (6).	Model 447, 448.8 except code XM7 (Facelift II) When replacing front 360° camera (B84).
6	Unclip molding (8) from holder (9).	Model 447, 448.8 except code XM7 (Facelift II) When removing molding (8) or holder (9).
7	Remove screws (10) and remove holder (9).	Model 447, 448.8 except code XM7 (Facelift II) When replacing holder (9).
8	Install in the reverse order.
9	Calibrate front 360° camera (B84) with diagnostic system.
			AD00.00-S-2000-04E