Remove/Install Outer Door Handle On Tailgate - AR72.20-S-7320E
Model 447, 448
MODIFICATION NOTES
| 25.9.15 | "Calibrate 360° rear camera with diagnostic system" added. | Operation step 10 |
Shown On vehicle With Code FR8 (Reversing camera)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove paneling from liftgate (2) | AR72.20-S-6445E | |
| 2 | Detach foil on liftgate (2) until outer door handle (1) is accessible | AR72.20-S-4100E | |
| 3 | Release and disconnect electrical connection (3) | ||
| 4 | Release and disconnect electrical connection (4) | Model 447, 448.8 with code FR8 (Rear view camera) Model 447.8, 448.8 with code JS1 (360° camera) |
|
| 5 | Release and disconnect electrical connector (5) | Model 447, 448.8 with code FR8 (Rear view camera) Model 447.8, 448.8 with code JS1 (360° camera) |
|
| 6 | Unscrew left and right nut (6) | ||
| 7 | Press catch hook (1.1) on outer door handle (1) in direction of outer door handle (1) on both sides and detach outer door handle (1) on liftgate (2) | ||
| 8 | Guide outer handle (1) through opening in liftgate (2) and remove | ||
| 9 | Install in the reverse order | ||
| Calibrate | |||
| 10 | Calibrate 360° rear camera with diagnostic system added | Model 447.8, 448.8 with code JS1 (360° camera) | |
| AD00.00-S-2000-04E |