Replace Reversing Camera (Code: VS2RUEKAM) - SM54.65-S-0030A

Model 447.603/605/703 #3 as of 000527 up to 470849 

with code FR8 (Rear view camera) 

with code ZU7 (National version for Canada) 

Model 447.603/605/703 #3 as of 000527 up to 470849 

with code FR8 (Rear view camera) 

with code ZU8 (National version for USA) 

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Replace reversing camera (code: VS2RUEKAM) For authorized Mercedes-Benz service partners, only the entry in the "Extended VEGA Application" (EVA) system, in the "Current" tab is decisive. There is no need to also check the affected vehicles in the workshop information system (WIS) or vehicle list.	SM54.65-S-0030-01A
	Replace
2	Replace reversing camera.
		Model 447 with CODE W65 (Liftgate)	AR54.65-S-0030E
		Model 447 except code W65 (Tailgate) Dispose of removed component parts that are no longer required properly. Observe the applicable legal requirements and specifications of the relevant country.	AR54.65-S-0030EE
	Perform initial startup
3	Install the 12 V charger.
		A sufficient power supply for the on-board electrical system battery must be guaranteed throughout the entire work procedure. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the 12 V charger. Use the 12 V charger to ensure an adequate voltage (min. 12.5 V) for the on-board electrical system battery.	AR54.10-S-1127E
4	Install vehicle diagnosis system.	If the vehicle diagnosis system is not yet installed.
		Always use the latest XENTRY Diagnosis software release. The operation steps in XENTRY Diagnosis must be followed precisely at all times.	AD00.00-S-2000-04E
5	Commission reversing camera using diagnostic system.	To do this, select the following menu items: Control units view → B84/3 or B84/5 or B84/20 - Reversing camera (RFK) (code: FR8) → Adaptations → Commissioning → Initial startup of already installed control unit You are then automatically guided through the steps "Updating of control unit software" and "SCN coding". It is absolutely essential to precisely follow the operation steps as described in the vehicle diagnosis system. A calibration drive is required after commissioning.
6	Remove vehicle diagnosis system from vehicle.
7	Remove the 12 V charger from vehicle.
			AR54.10-S-1127E
8	Perform calibration drive for reversing camera.