Remove And Install Front End CROSSMEMBER - Ar62.30-P-2300GW

Model 463 

as of model year 2013 up to model year 2019 

Illustration shows engine 157 

Fig 1: Radiator Crossmember, Components And Locations

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Remove radiator grille		AR88.00-P-2115GW
2	Unhook wire (3) at bottom of radiator crossmember (1), for this purpose unclip retaining clips	Check retaining clips, replace if required.
3	Unclip retaining clips for coolant line at bottom of radiator crossmember (1)
4.1	Unscrew bolts (2) and remove radiator crossmember (1) upward together with engine hood lock	Model 463 as of model year 2016 up to model year 2019 Model 463 as of model year 2016 up to model year 2019 Bolt, radiator crossmember to front end	*BA83.30-P-1014-01C
4.2	Unscrew bolts (2) and remove radiator crossmember (1) upward together with engine hood lock	Model 463 as of model year 2013 up to model year 2016
5	Remove wire (3) from engine hood lock	Model 463 as of model year 2013 up to model year 2016	AR88.40-P-3200GW
6	Install in the reverse order