Remove/Install Lower Side Trim In Rear Passenger Compartment - AR68.30-P-4784LWO
Model 238
Shown on right side of vehicle on model 238.3
Shown on bottom right trim (1) on model 238.3 with code 872 (seat heater in rear passenger compartment)
| Remove/install | |||
| 1.1 | Remove right rear backrest | When removing bottom right trim (1). Model 238.3 |
AR91.12-P-1722LWO |
| Model 238.4 | AR91.12-P-1721LWR | ||
| 1.2 | Remove left rear seat backrest | When removing bottom left trim (1). Model 238.3 |
AR91.12-P-1724LWO |
| Model 238.4 | AR91.12-P-1721LWR | ||
| 2 | Remove upper trim in rear | AR68.30-P-4783LWO | |
| 3 | Remove door sill molding | AR68.30-P-4100CLW | |
| 4 | Unscrew bolts (2) | Three bolts (2) have been installed. |
|
| 5 | Detach edge guard (3) in area of bottom trim (1) | ||
| 6 | Unclip bottom trim (1) in area of retention clips (4) from the body | Carefully unclip bottom trim (1). Otherwise, the electrical lines beneath it may be damaged. |
Fig 1 |
| 7 | Disconnect electrical connection (5) | ||
| 8 | Disconnect electrical connector (6) | Model 238 with code 872 (Heated rear seats) | |
| 9 | Remove bottom trim (1) | ||
| 10 | Install in the reverse order |